FVA-Workbench 7.1.1
Features
New evaluateAllFormulaCells() scripting function executes all calculations stored in Excel cells
Added confirmation prompt if temperature is not specified in FKM calculation
Increased maximum number of total system iterations from 50 to 500
Bugfixes
Corrected load-dependent relative position (bevel tip displacements) of bevel gears on FE shafts
Corrected gearbox torsion angle (input/output) for gears on FE shafts
Changed to relative tolerance for snapping nodes on FE shafts
Corrected an attribute unit for life calculation module
Added missing directory for execution of Z88 postprocessor
Corrected cross-section calculation for "transverse bore" notch type
Corrected impact factor for compression load for DIN743 calculation (previously always set to 1.0)
Enabled dynamic tension-compression load for DIN743 calculation
Removed license warning dialogs in batch mode
Corrected bearing display in 3D View if housing is on the inner side of the bearing
Corrected form factor calculation in VDI 2736
Corrected transfer of "scuffing calculation according to DIN 3990" switch from older models
Corrected error in friction calculation of spherical roller bearings without radial load